AABCOOLING Super Silent Fan 9
- AABCOOLING Super Silent Fan 9 – quiet 92 mm fan, 1600 rpm. FDB bearing with 100,000 h service life, airflow 58 m³/h, noise 13.6 dB(A). For PC cases, ATX power supplies and CPU coolers.
Subscription products in your shopping cart
Set one delivery frequency for all subscription products in your cart every:
Subscription products in your shopping cart
Quiet 92 mm fan for case, PSU and CPU cooler
AABCOOLING Super Silent Fan 9 is a quiet, well-built 92 mm fan. Silicone anti-vibration pads for the screws are included to reduce vibration.
The fan runs at a constant speed of 1600 rpm ±10%. It delivers an airflow of 58 m³/h at a noise level of 13.6 dB(A), making it a quiet and efficient fan in its class.
Smooth, quiet operation is ensured by the FDB (Fluid Dynamic Bearing) with a service life of 100,000 hours – considerably longer than that of conventional sleeve bearings.

Key features
- Solid construction: 92 × 92 × 25 mm
- Modern IC motor
- Cable in black braided sleeve
- Quiet FDB bearing (Fluid Dynamic Bearing)
- Airflow: 58 m³/h
- Noise level: 13.6 dB(A)
- Service life: 100,000 h
- Mounting screws and anti-vibration pads included
Applications
The fan expels warm air from the computer case – where the power supply fan alone is often not enough, despite high speed and loud operation. With dimensions of 92 × 92 × 25 mm, it can be installed:
- on the front, rear or side panel of a PC case
- on the CPU heatsink – replacing a noisy fan
- in an ATX computer power supply
FDB bearing
Conventional sleeve bearings rub against each other during operation, heat up and wear out faster. The FDB bearing offers:
- no friction and a longer service life
- vibration damped by the oil film
- low noise – only the blades can be heard
- protection against oil leakage
- spiral oil distribution for even lubrication of the whole bearing
- a solution proven in hard disk drives
Installation in the case or power supply
The fan is fixed with four screws, just like standard power supply fans, so replacing a noisy fan is quick and easy. In a power supply it can be connected in two ways:
- To the fan header on the motherboard – route the cable (30 cm) into the power supply through a small gap. The fan speed can then be read in the BIOS.
- Directly inside the power supply after taking apart the 3-pin plug: black wire – ground (−), red – power (+), yellow – speed signal (without it the BIOS cannot read the speed).
Note: taking apart or cutting off the plug excludes the possibility of returning the product.

Specifications
- Dimensions: 92 × 92 × 25 mm
- Mounting hole spacing: 82 × 82 mm
- Weight: 73 g
- Material: plastic
- Power supply: 5–12 V DC / 0.02–0.09 A / 0.1–1.08 W
- Connector: 3-pin
- Speed: 1600 rpm ±10%
- Airflow: 58 m³/h
- Noise level: 13.6 dB(A)
- Bearing: FDB (Fluid Dynamic Bearing)
- Service life: 100,000 h
- Cable length: 30 cm

Package contents
- 1 × AABCOOLING Super Silent Fan 9
- 4 × mounting screws
- 4 × anti-vibration pads
- packaging






















